Display Ospfv3 Request-List - HP 6125G Command Reference Manual

Description
Use display ospfv3 peer statistics to display information about all OSPFv3 neighbors on the
router—numbers of neighbors in different states.
Examples
# Display information about all OSPFv3 neighbors.
<Sysname> display ospfv3 peer statistics
----------------------------------------------------------------------
Area ID
0.0.0.0
Total
Table 55 Command output
Field
Area ID
Down
Init
2-Way
ExStart
Exchange
Loading
Full
Total

display ospfv3 request-list

Syntax
display ospfv3 [ process-id ] request-list [ { external | inter-prefix | inter-router | intra-prefix | link |
network | router | grace } [ link-state-id ] [ originate-router ip-address ] | statistics ] [ | { begin | exclude
| include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
process-id: OSPFv3 process ID, in the range of 1 to 65535.
OSPFv3 Router with ID (1.1.1.1) (Process 1)
Neighbor Statistics
Down Init
0 0
0 0
Description
Area ID.
In this state, neighbor initial state, the router has not received any information from a
neighboring router for a period of time.
In this state, the device received a Hello packet from the neighbor but the packet contains
no Router ID of the neighbor. Mutual communication is not setup.
Indicates mutual communication between the router and its neighbor is available.
DR/BDR election is finished under this state (or higher).
In this state, the router decides on the initial DD sequence number and master/slave
relationship of the two parties.
In this state, the router exchanges DD packets with the neighbor.
In this state, the router sends LSRs to request the neighbor for needed LSAs.
Indicates LSDB synchronization has been accomplished between neighbors.
Total number of neighbors under the same state.
2-way ExStar Exchange Loading
0 0 0
0 0 0
243
Full
0 1
0 1