Default Cost; Default-Cost (Ospfv3 Area View) - HP 6125G Command Reference Manual
Layer 3 - ip routing
Hide thumbs
Also See for 6125G:
- Command reference manual (426 pages) ,
- Configuration manual (379 pages) ,
- Release note (60 pages)
Table of Contents
Advertisement
[Sysname] ospfv3 1
[Sysname-ospfv3-1] bandwidth-reference 1000
default cost
Syntax
default cost value
undo default cost
View
OSPFv3 view
Default level
2: System level
Parameters
value: Specifies a default cost for redistributed routes, in the range of 1 to 16777214.
Description
Use default cost to configure a default cost for redistributed routes.
Use undo default cost to restore the default.
By default, the default cost is 1.
You need to configure the default cost value for redistributed routes to advertise them throughout the
whole AS.
Examples
# Specify the default cost for redistributed routes as 10.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] default cost 10
default-cost (OSPFv3 area view)
Syntax
default-cost value
undo default-cost
View
OSPFv3 area view
Default level
2: System level
Parameters
value: Specifies a cost for the default route advertised to the stub area, in the range of 0 to 65535. The
default is 1.
Description
Use default-cost to specify the cost of the default route to be advertised to the stub area.
228
Advertisement
Table of Contents
