Selection Of Batch Weighing - AND Multi Function Weighing Indicator AD-4402 Instruction Manual

7.2.1. 7.2.1.

Selection of Batch Weighing

Selection of Batch Weighing
7.2.1. 7.2.1. Selection of Batch Weighing Selection of Batch Weighing
Selection of Normal Batching or Loss-in-weigh
The mode can be selected at
([Function] - [Function setting] - [Sequence] - [Basic] - [Current weighing])
[5q f- 3] [0]
[5q f- 3] [1]
[5q f- 3] [2]
External Selection (Normal batch weighing or Loss-in-weigh)
Normal batch weighing and Loss-in-weigh can be selected by a signal at the input
terminal that is set to [9] of
(The menu [Function] - [Function setting] - [Control I/O Function] - [Input] )
Example of use: 100 kg of material is supplied to the hopper in the first step. It is
subdivided into material of 10 kg.
Advise
If the mode is switched concerning a specified material only, set the hopper no. in the
material code, short the hopper no. output line and the supply/discharge switch input
line. Set the delay timer [5q f-32] to "above 0.1sec.".
AD-4402
Loss-in-weigh
Normal batch weighing
Loss-in-weigh
External selection (Normal batch weighing or Loss-in-weigh)
External switch control
Page 37
in the Function list.
.