Safety Check Function; Pause And Emergency Stop - AND Multi Function Weighing Indicator AD-4402 Instruction Manual

7.3.10. 7.3.10. Safety Check Safety
7.3.10. 7.3.10. Safety Safety
This function is used to stop the sequence when an error or an emergency happens.
When the function works, an error code is displayed and an error signal is output from
the preset I/O terminal that
[Function] - [Function setting] - [Control I/O ] - [Output].
The control inputs of the function, use the preset I/O terminals or OP-05 terminals that
safety check
select
In maximum, eight input terminals can be used.
The safety check functions are as follows:
Code
5qf-71
5qf-72
5qf-73
5qf-74
5qf-75
7.3.11. 7.3.11. Pause and Emergency Pause and
7.3.11. 7.3.11. Pause and Pause and
The pause input is used to stop the sequence temporarily.
When the sequence pauses,
The emergency stop input is used to stop the sequence.
When the sequence is stopped, alarm1 is informed and No.
When the emergency stop is canceled, the status moves to the pause (temporary stop).
Refer to section "7.5.11.Error Message and Alarm" for the details.
The I/O terminal and OP-05 terminal can be assigned to the pause input and
emergency input.
Concerning Parameters of the Function
Selecting the I/O terminal as the pause input or the emergency input.
[1n f-nn] [22]
[1n f-nn] [13]
Selecting the OP-05 terminal as the pause input or the emergency input.
[05 f-nn] [22]
[05 f-nn] [13]
Check Function
Check Check
weighing sequence error
.
Classification
Condition of the start
Condition of the discharge
Condition of the recipe (compound)
Condition of the mix
Condition of the whole sequence
Emergency Stop
Emergency Emergency
SQ.ERR 0
Pause
(Temporary stop)
Emergency Stop
nn: terminal number of I/O.
[Function] - [Function setting] - [Control I/O Function] - [Input]
Pause
(Temporary stop)
Emergency Stop
nn: terminal number of I/O.
[Function] - [Function setting] - [slot kk]
kk: The slot number that OP-05 is installed in.
Function
Function Function
Stop
Stop Stop
is displayed and an error code is output.
Page 56
[22] is selected at
Action
Specify the safety confirmation
inputs on the I/O or OP-05.
When all inputs are not ON
(active), the sequence is stopped,
an error code is displayed.
alarm 19
is displayed.
AD-4402