Config Transfer - ADTRAN ATLAS 800 SERIES System Manual

ATLAS 800 Series System Manual

Config Transfer

Write security: 3; Read security: 5
(Available with TFTP transfers only.) Sends a file containing the ATLAS 800 Series configuration to a file
on a TFTP server using the TFTP protocol through the 10/100BaseT Ethernet port.
lets you save the ATLAS 800 Series configuration as a backup file, so you can use the same configuration
with multiple ATLAS 800 Series units. In addition,
from a TFTP server.
To support these transfers, ADTRAN delivers a TFTP program with the ATLAS 800 Series called
TFTP Server. You can configure any PC running Microsoft Windows with this software, and store a
configuration file.
Only one configuration transfer session (upload or download) can be active at a time. The TCP/IP
parameters are not saved or overwritten as part of an ATLAS 800 Series unit's transferred configuration;
therefore, identical configurations can be sent to multiple units. For complete details on configuration
transfers to/from the ATLAS 800 Series, please refer to DLP-8, Saving the Current Configuration using
TFTP.
Transfer Method
TFTP Server
IP Address
TFTP Server
Filename
Current Transfer
Status
Previous Transfer
Status
Load and Use Config
Save Config Remotely
61200780L1-1C
Displays the method used to transfer the configuration file to or from a server.
Currently, TFTP is required.
Specifies the IP address of the TFTP server. Get this address information from
your System Administrator.
Defines the name of the configuration file that you transfer to or retrieve from
the TFTP server. The default name is at830.cfg, but it is editable.
Read security: 5
Indicates the current status of the transfer.
Read security: 5
Indicates the status of the previous transfer.
Retrieves the configuration file specified in the
from the server. To start this command, enter
enter N
.
If you execute the
retrieves the configuration file, reboots, then restarts using the new
configuration.
Saves the configuration file specified in
identified in TFTP S
ERVER
cancel this command, enter
© 2004 ADTRAN, Inc.
System Utility Menu Descriptions
can retrieve a configuration file
C T
ONFIG RANSFER
TFTP S
To cancel this command,
Y
.
L U C
OAD AND SE ONFIG
TFTP S
ERVER
IP A . To start this command, enter
DDRESS
.
N
Config Transfer
C T also
ONFIG RANSFER
F field
ERVER ILENAME
command, ATLAS
to the server
F
ILENAME
Y . To
96