ADTRAN ATLAS 800 SERIES System Manual page 303

ATLAS 800 Series System Manual
Submenu
D64, D56, Audio,
Speech
Strip MSD
Source ID
Swap ANI/DNIS
Outgoing Caller ID
61200780L1-1C
Descriptions (Continued)
These options reflect the network provisions for this SPID. If the BRI was
purchased with different services provisioned for the SPIDs, then the call must
match the services supported.
Strips a selected quantity (choose from
significant digits (MSD) of a dialed number prior to being forwarded out of the
port.
Example: A network port could be set to accept all calls beginning with 9 (9$),
and then with S MSD
TRIP
except the leading 9.
S MSD does not affect C
TRIP
MSDs that are subsequently stripped) are used as accept criterion.
Simplifies the creation of a dial plan in applications where the criterion for
switching calls to a certain endpoint is a function of which endpoint originated
the call.
• D = 0 . Zero is the default ID for all endpoints and all accept
EFAULT VALUE
numbers. With default values, all calls are routed based only on the dialed
number.
• Multiple endpoints can have the same
• When creating the C
dialed number or range of dialed numbers to accept.
For example, an application requires that all calls that originate from Port 1 of
the ATLAS 800 Series in Slot 1 be switched to Port 2 of that same module.
Assign a unique S
OURCE
Port 2 to only accept calls from that unique
Swaps the ANI and DNIS numbers received from the network. ANI (Automatic
Number Identification) is the billing number of the calling party, and DNIS
(Dialed Number Identification Service) is the called party number.
Defines the number for the ATLAS 800 Series to use to provide Caller ID to the
Network for outgoing calls sent through this endpoint. Choose from
, S
PROVIDED UBSTITUTE IF NOT PRESENT
The Caller ID number must be specific (i.e., no wildcards).
© 2004 ADTRAN, Inc.
Octal BRI/U: User Term - Ifce Config
N , 1, 2,
ONE
set to 1 , all digits would be sent toward the network
A criteria. All of the digits (including the
ALL CCEPT
S
OURCE
A list, specify a
ALL CCEPT
ID (e.g., 7) to Port 1 of the module, and then configure
S
OURCE
, or S
UBSTITUTE ALWAYS
Dial Plan
and of the most
3)
.
ID
S ID (s) as well as a
OURCE
(7).
ID
S
END AS
.
303