Dlp-7 Updating Atlas Firmware Using Xmodem - ADTRAN ATLAS 800 SERIES System Manual

DLP-7 Updating ATLAS Firmware using XMODEM

Introduction
The ATLAS supports firmware updates via the E
the A or C
interfaces using XMODEM. This procedure outlines the steps for a successful
DMIN RAFT
firmware upgrade using the A
Tools and Materials Required
• VT100 terminal or PC with VT100 terminal emulation software
• XMODEM software
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Electronic modules can be damaged by static electrical discharge. Before handling modules,
wear an antistatic discharge wrist strap to prevent damage to electronic components. Place
modules in antistatic packing material when transporting or storing. When working on
modules, always place them on an approved antistatic mat that is electrically grounded.
XMODEM Instructions for Updating Firmware
1. Connect to the ATLAS using the DB-9 A
If you are not already connected to the unit's A
VT100 compatible terminal or with a PC running VT100 emulation software), follow the procedure in
DLP-1, Connecting the Terminal or PC to the ADMIN or CRAFT Port. Connecting to the
C interface limits the upgrade procedure to XMODEM Only.
RAFT
2. Login to the unit using the read-write password (see DLP-5, User Access and Password Security
Levels, on page 327 for details).
3. Go to the S
YSTEM
4. Select the M
ODULE
Select S 0 to update the System Controller.
LOT
Selecting A
LL
update process.
61200780L1-1C
or C
interfaces and XMODEM software.
DMIN RAFT
DMIN
U menu and select the U
TILITY
S menu and press <Enter>. Select the appropriate module slot to update.
LOT
M T
ODULES OF A YPE
© 2004 ADTRAN, Inc.
port using either TFTP from a network server or
THERNET
or C interface, or the RJ-45 ADMIN port.
RAFT
or C
interface (either with a
DMIN RAFT
F
PDATE IRMWARE
and S C
will force a controller reboot during the
YS TRL
A
DMIN
menu; press <Enter>.
or
332