Download Print this page

ADTRAN ATLAS 890 Quick Start

System controller
Hide thumbs Also See for ATLAS 890:

Advertisement

Quick Links

Quick Start
Technical Support (888) 4ADTRAN (423-8726)
ATLAS 890 SYSTEM CONTROLLER
MODULE FACEPLATE LEDS
ACTIVE LED
Description
Green
Active Controller
Blinking Green
Stand-by Controller - redundancy enabled
Blinking Red
Stand-by Controller - cannot automatically
become the active Controller while the
current active Controller is installed
ONLINE LED
Description
Off
Blown fuse
Green
Online
Blinking Green
Offline
Red
Card failure
Blinking Red
Self-test failure
Amber
Self-test in progress
Blinking Amber
Module update in progress
LINK LED
Description
Off
Ethernet link not detected
Green
Ethernet link detected
SPECIFICATIONS
Menu Access
VT-100/Telnet
Ethernet
10/100 Base-T
Compliance
FCC Part 15, UL 1950
Temperature
Operation: 0 to 50 °C
Storage: –40 to 70 °C
Relative Humidity
To 95% noncondensing
Power
21 watts (active), 15 watts (stand-by)
Warranty
5 years
April 2001
61200322L1-13A
FRONT PANEL LEDS
STATUS LED
Green
Slow Blinking Green Stand-by Controller - redundancy enabled
ONLINE LED
Solid Green
Fast Blinking Green
Fast Blinking Red
TEST LED
Amber
LINK LED
Off
Green
INSTALLATION INFORMATION
• Insert the module into the slot labeled CONTROLLERS
ONLY A or B.
• Connect a VT-100 terminal configured for 9600 baud (8N1) to
the female RJ-48 Admin port on the front of the Controller.
After the Controller has booted, the LOGIN prompt will
appear on the VT-100 terminal (if connected to the active
Controller). Otherwise, a message indicating connection to
the stand-by Controller will be displayed if the VT-100
terminal is so connected.
• Menu access to the active Controller is also available through
the Craft port on the front of the unit.
• To configure the ethernet port, use the arrow keys and Enter
key to navigate the following path:
SystemConfig/EthernetPort
Copyright © 2001 ADTRAN All rights reserved
Description
Active Controller
Description
Active Controller
Non-critical incompatibility
Cannot automatically become the active
Controller while the current active
Controller is installed
Description
Test in progress
Description
Ethernet link not detected
Ethernet link detected

Advertisement

loading

Summary of Contents for ADTRAN ATLAS 890

  • Page 1 April 2001 Quick Start Technical Support (888) 4ADTRAN (423-8726) 61200322L1-13A Copyright © 2001 ADTRAN All rights reserved ATLAS 890 SYSTEM CONTROLLER MODULE FACEPLATE LEDS FRONT PANEL LEDS STATUS LED Description ACTIVE LED Description Green Active Controller Green Active Controller Slow Blinking Green Stand-by Controller - redundancy enabled...
  • Page 2 Dial Plan The Dial Plan menu allows you to set global ATLAS 890 switch parameters or set individual parameters for each port in the ATLAS 890 that handles a switched endpoint.