ADTRAN ATLAS 800 SERIES System Manual page 318

ATLAS 800 Series System Manual
Connecting a Terminal to the ATLAS
VT100 Terminal
1. Set the VT100 terminal parameters as follows:
• 9600 baud rate
• 8 data bits
• No parity
• 1 stop bit
• No flow control
2. If the terminal has a parallel setting, disable it and use serial port.
3. Plug the male end of the DB-9 (or RJ-45) data cable into the ATLAS.
4. Make the connection to the VT100 terminal as appropriate for your equipment.
PC Emulating a VT100 Terminal
Most personal computers or laptops can run communications software that will emulate a VT100
terminal—for example, Terminal
packages will also allow your PC or laptop to emulate a VT100 terminal. However, certain configuration
items must be set on a PC or laptop to act as a VT100 terminal for the ATLAS.
1. Set the VT100 terminal parameters as follows:
• 9600 baud rate
• 8 data bits
• No parity
• 1 stop bit
• No flow control
2. Set the PC for direct connect on the appropriate COM port (instead of dial-up connection).
3. Plug the DB-9 (or RJ-45) male end of the data cable into the ATLAS.
4. Make connection to the PC or laptop as appropriate for your equipment.
You are now ready to login to ATLAS, as described in DLP-2,
Follow-up Procedures
Once this procedure is complete, return to the procedure which referred you to this DLP and continue with
the tasks indicated there.
61200780L1-1C
© or Hyperterminal ©. . Many other commercially available software
© 2004 ADTRAN, Inc.
System Login and Menu Access,
on page 319.
318