ADTRAN ATLAS 800 SERIES System Manual page 292

ATLAS 800 Series System Manual
Submenu
Port
Interface Number
Backup D Channel
Switch Type
First DS0
Number of DS0s
Strip MSD
Network Specific Facility
Voice and Data
61200780L1-1C
Description (Continued)
Configures the port that the interface is physically connected to.
Configures the NFAS Interface ID associated with the interface. The configure
ID must match the ID configured by the provider.
Backup D channel is not supported on User Term NFAS interfaces.
Only one backup D channel can be configured per NFAS interface group.
Defines the type of PRI switch to which the port is connected. If connected to
another ATLAS 800 Series, both need to be set to the same switch type. The
following options are available:
and
N ISDN.
ATIONAL
Defines to the ATLAS 800 Series the first DS0 for this endpoint. The
ATLAS 800 Series uses DS0s, starting with this selection, to send and receive
calls to and from the network. The outgoing calls which are allowed or
restricted over these DS0s are set by
and O #R (see
Submenus
UT EJECT
Specifies the number of DS0s ATLAS 800 Series uses for this endpoint.
Strips a selected quantity (choose from
significant digits (MSD) of a dialed number prior to being forwarded out of the
port.
Example: A network port could be set to accept all calls beginning with 9 (9$),
and then with
S MSD
TRIP
except the leading 9.
S MSD does not affect C
TRIP
MSDs that are subsequently stripped) are used as accept criterion.
Enables the sending of appropriate information to the PSTN. The default for this
option is N , and in this case no Network Specific Facility Information
ORMAL
Element is sent. Unless one of the services listed below is subscribed to, the
selection should remain set to
The list below indicates services that may be subscribed to from the PSTN.
These services require that specific information (such as a Network Specific
Facility Information Element) be sent to the network during call setup.
• AT&T Accunet
• AT&T Dial-It 900/Multiquest
• AT&T International-800
• AT&T Long Distance
• AT&T Megacom 800
• AT&T Megacom
© 2004 ADTRAN, Inc.
T3 and T3 D&I: User Term - Ifce Config (NFAS)
AT&T 4ESS , L
UCENT
O #A
UT CCEPT
on page 274).
N , 1, 2,
ONE
set to , all digits would be sent toward the network
1
A
criteria. All of the digits (including the
ALL CCEPT
N .
ORMAL
Dial Plan
5E , N DMS 100
ORTHERN
(see on page 268)
Out#Accept
and 3 ) of the most
,
292