ADTRAN ATLAS 800 SERIES System Manual page 212

ATLAS 800 Series System Manual
Session Status
Read security: 5
Shows the status of key DTE interface signals. An asterisk (*) indicates the presence of a signal and a
hyphen (-) indicates no signal present.
Prt
Mode
Submenu
Unassigned
Idle
Loopback
Modem Ring
Modem Answer
Modem Dial
Modem Connected
ISDN PPP Ring
ISDN PPP Answer
ISDN PPP Dial
ISDN PPP
Connected
Call Dir
Rsc
Last Disconnect
Hangup
61200780L1-1C
Displays the port number.
Indicates the session mode for the port. The following modes are available:
Description
Port not assigned to a phone number in the Dial Plan.
Port assigned but no call is active.
Loopback is turned on in the test menu.
Incoming analog modem call is ringing on port. Async-232 port will toggle RI.
The DTE has answered an incoming analog modem call.
The DTE is using the Async-232 port to make an outgoing analog modem call.
An analog modem call has been established.
Incoming ISDN PPP call is ringing on the port. Async-232 port will toggle RI.
The DTE has answered an incoming ISDN PPP call.
The DTE is using the Async-232 port to make an outgoing ISDN PPP call.
An ISDN PPP call has been established.
Read security: 5
Displays the current call direction as
active call, will display.
I
DLE
Read security: 5
This field indicates the slot and device number allocated for a call to or from
this port. If no call is active, it will indicate
either an analog modem, or an ISDN digital call resource.
Read security: 5
This field indicates the reason for the last call disconnect or dialout failure for
this port. If no call has been attempted for the given port, this field will indicate
N . This information is also available in the system log if Async-232 module
ONE
events are enabled.
Write security: 3; Read security: 5
Activator used to hangup the current active call on the port.
© 2004 ADTRAN, Inc.
Async-232 Option Module
I or O . If there is no
NCOMING UTGOING
. The allocated resource will be
N
ONE
Session Status
212