ADTRAN ATLAS 800 SERIES System Manual page 286

ATLAS 800 Series System Manual
Source ID
Swap ANI/DNIS
B Channel Selection
Submenu
Normal
Circular
Busy Option
Submenu
Normal
Pass-Thru
61200780L1-1C
Simplifies the creation of a dial plan in applications where the criterion for
switching calls to a certain endpoint is a function of which endpoint originated
the call.
• . Zero is the default ID for all endpoints and all accept
D = 0
EFAULT VALUE
numbers. With default values, all calls are routed based only on the dialed
number.
• Multiple endpoints can have the same
• When creating the
C
dialed number or range of dialed numbers to accept.
For example, an application requires that all calls that originate from Port 1 of
the ATLAS 800 Series in Slot 1 be switched to Port 2 of that same module.
Assign a unique
S
OURCE
Port 2 to only accept calls from that unique
Swaps the ANI and DNIS numbers received from the network. ANI (Automatic
Number Identification) is the billing number of the calling party, and DNIS
(Dialed Number Identification Service) is the called party number.
With this swap, the ATLAS 800 Series switchboard uses ANI to route the call. The
accept number in the dial plan must use the ANI number, not the DNIS number.
The following
B C
HANNEL
Series switchboard uses B channels for call routing. The Circular method can be
used for call load balancing among the available B channels on this interface.
Descriptions
Always start with the last channel configured (i.e., for a full PRI channel 23
would be used if available).
Contiguous channels from last to first
The following
B O
USY PTION
CPE upon receipt of a D
Descriptions
Send a Progress message to the CPE and map busy tones.
Send a
D U
ISCONNECT SER
© 2004 ADTRAN, Inc.
T3 and T3 D&I: Network Term - Ifce Config (NFAS)
S
OURCE
list, specify a
A
ALL CCEPT
(e.g., 7) to Port 1 of the module, and then configure
ID
S
OURCE
submenus determine how the ATLAS 800
S
ELECTION
submenus define the response propagated to the
U -B message from the network.
ISCONNECT SER USY
message to the User Term CPE device.
-B
USY
Dial Plan
ID .
(s) as well as a
S ID
OURCE
ID (7).
286