ADTRAN ATLAS 800 SERIES System Manual page 272

ATLAS 800 Series System Manual
User Term
Write security: 3; Read security: 5
This menu allows you to define option parameters for ports which terminate a connection from user
equipment. In this case, ATLAS 800 Series is acting as the network.
In applications where two ATLAS 800 Series units are used in a point-to-point configuration, a port in the
ATLAS 800 Series at one end would act as the network (user termination), while the ATLAS 800 Series at
the opposite end would be terminating a network connection (network termination).
Slot/Svc
Port/PEP
Sig
In#Accept
Submenus
Src ID
61200780L1-1C
Selects the ATLAS 800 Series slot or service that terminates a user connection.
Selects the ATLAS 800 Series port or packet endpoint that terminates a network
connection. More than one "endpoint" can be associated with a particular port.
If a T1 is connected to the PSTN, some DS0s may be used for long distance,
while others are used for local calls. These would constitute two "endpoints"
(trunks) over a single physical port.
Defines the type of signaling being used for this connection (endpoint). Select
RBS for a T1 using robbed bit signaling or
interface. Select NFAS for a non-facility associated signaling interface or
for OSC when bonding DS0s. This selection is only necessary if a T1/PRI is
selected as the S /P
LOT ORT
One HDLC resource is used by each PRI or each Packet Endpoint.
The following
I #A
N CCEPT
calls that ATLAS 800 Series accepts from the network.
Description
Identifies the call source ID from which this endpoint accepts calls. This field
simplifies the creation of a dial plan in applications where the criterion for
switching calls to a certain endpoint is a function of which endpoint originated
the call. S ID may be entered with the usual wild card entries (except $).
RC
X = Any digit 0 through 9
[1,2,3...] = A single digit in this group
0 = Default value
The default ID for all source endpoints all accept numbers is 0. This results in
all calls being routed based on the dialed number
© 2004 ADTRAN, Inc.
PRI for a Primary Rate ISDN
type.
submenus define the parameters for the incoming
Dial Plan
User Term
N
ONE
272