ADTRAN ATLAS 800 SERIES System Manual page 338

ATLAS 800 Series System Manual
3. Configure the modem as follows:
• 9600 baud rate
• 8 data bits
• No parity
• 1 stop bit
• Flow control - Hardware
• Auto Answer - On
• DTR - Idle (when Off/normal on the modem with ATLAS in dial mode)
The unit may be left in direct mode with DTR set to I
on logoff and authentication failure will be lost.
4. ATLAS 830
Connect the male DB-9 connector of the data cable to the female DB-9 connector, labeled A
located on the back of the unit.
ATLAS 890
Connect the male RJ-45 connector of the data cable to the female RJ-45 connector, labeled A
located on the back of the unit in the middle of the S
5. Route the data cable to the modem.
6. ATLAS 830
Connect the other end of the cable to the DB-9 end of the connector (DB-9 to male DB-25). Then,
connect the DB-25 end of the connector to the modem, configured as described above.
ATLAS 890
Connect the other end of the cable to the RJ-45 end of the connector (RJ-45 to male DB-25). Then,
connect the DB-25 end of the connector to the modem, configured as described above.
7. Connect the modem to the POTS line as required by the manufacturer.
8. Login to the ATLAS system. (Refer to DLP-2, System Login and Menu Access, on page 319 for
detailed instructions.)
9. From the M M
AIN ENU
right-pane menus.
10. From the S C
YSTEM
P
menus, press the right arrow key to enter the right-pane menus.
ORT
The A port may be configured via Telnet or the C
DMIN
61200780L1-1C
, select the S C
YSTEM
menu, select the A
ONFIG
© 2004 ADTRAN, Inc.
; however, automatic disconnect
GNORE
C
YSTEM ONTROLLER
menu and press the right arrow key to enter the
ONFIG
P menu and press <Enter>. Once in the A
DMIN ORT
port.
RAFT
,
DMIN
,
DMIN
module.
DMIN
338