ADTRAN ATLAS 800 SERIES System Manual page 295

ATLAS 800 Series System Manual
Network Specific Facility
Voice and Data
Called Digits
Transferred
Outgoing Caller ID
Source ID
Swap ANI/DNIS
61200780L1-1C
Enables the sending of appropriate information to the PSTN. Currently not
supported for E1/PRA use.
Some PRI switches may be provisioned to send only a portion of the called
number (like DID). This menu item allows the ATLAS 800 Series to know how
many digits to expect (choose from
default is A and would almost always be correct. If less than
LL
sent, then the is defined as follows:
P
REFIX
displays only if
P C
REFIX
prefix for the digits received. For example, if the number of digits is four and
the number called is 963-8615, the telco's PRI switch sends only 8615 and the
prefix is set to 963. This entire number is then used to determine which
ATLAS 800 Series user port endpoint should receive the call.
Defines the number to use to provide Caller ID to the network for outgoing calls
sent through this endpoint. Choose from
, or S
PRESENT UBSTITUTE ALWAYS
The Caller ID number must be specific (i.e., no wildcards).
Simplifies the creation of a dial plan in applications where the criterion for
switching calls to a certain endpoint is a function of which endpoint originated
the call.
• . Zero is the default ID for all endpoints and all accept
D = 0
EFAULT VALUE
numbers. With default values, all calls are routed based only on the dialed
number.
• Multiple endpoints can have the same
• When creating the
C
dialed number or range of dialed numbers to accept.
For example, an application requires that all calls that originate from Port 1 of
the ATLAS 800 Series in Slot 1 be switched to Port 2 of that same module.
Assign a unique
S
OURCE
Port 2 to only accept calls from that unique
Swaps the ANI and DNIS numbers received from the network. ANI (Automatic
Number Identification) is the billing number of the calling party, and DNIS
(Dialed Number Identification Service) is the called party number.
With this swap, the ATLAS 800 Series switchboard uses ANI to route the call. The
accept number in the dial plan must use the ANI number, not the DNIS number.
© 2004 ADTRAN, Inc.
E1/PRA: Network Term - Ifce Config (PRA)
N , T
ONE HREE
D T
ALLED IGITS RANSFERRED
S
END AS PROVIDED
.
S
OURCE
list, specify a
A
ALL CCEPT
(e.g., 7) to Port 1 of the module, and then configure
ID
S
OURCE
Dial Plan
and ). The
, F , S , A
OUR EVEN LL
A digits are
LL
is not set to . Enter the
A
LL
, S
UBSTITUTE IF NOT
ID .
(s) as well as a
S ID
OURCE
ID (7).
295