Download Print this page

ADTRAN Atlas 830 Quick Start Manual

Adtran bridge/router quick start guide
Hide thumbs Also See for Atlas 830:

Advertisement

Quick Links

ATLAS 830
Quick Start Guide
Reviewing the Front Panel
Controller LEDs
ACO Switch
Connecting to the ATLAS 830
Connecting a VT100 terminal (or VT100 terminal emulator) to the C
interface (on the front panel of the unit) or the A
of the unit) allows access to the terminal menus and management features of
the ATLAS 830.
Perform Steps Below in the Order Listed:
1. Configure a VT100 terminal (or terminal emulation software) with the
following settings:
Data Rate:
9600 baud
Data Bits:
8
Parity Bits:
None
If the terminal has a parallel setting, disable it and use serial.
2. Connect the DB-9 male end of the data cable into the ATLAS 830 C
A
port. Make the connection to the VT100 terminal as appropriate for
DMIN
your connection.
3. Initiate a terminal session and the L
password is password. (Passwords in the ATLAS 830 are case sensitive.)
Quick Start Guide, 61200780L1-13A, August 2002
Network Ports LEDs
NE TW O RK
1
2
PO WER
OK
OK
SYSTEM
TES T
TES T
ACO
CR AF T
ETH ERN ET
ERR OR
ERR OR
REMOTE
ALARM
ALARM
Craft Interface
RAFT
interface (on the rear panel
DMIN
Stop Bits:
1
Flow Control:
None
screen displays. The default
OGIN
Technical Support 1-888-4ADTRAN (1-888-423-8726)
For more detailed documentation, visit us online at
Option Module LEDs
MODULES
1
2
3
4
5
6
7
8
STATUS
ONLINE
TES T
Craft Pinout
PIN
NAME
1, 4, 6-9
N/A
2
RD
3
TD
5
SG

System Status LEDs

The System Status LEDs display the status of the power supply, controller, and
other system parameters for the ATLAS 830. For a more detailed discussion of
the front panel LEDs, refer to Section 2, Engineering Guidelines, of the ATLAS
830 System Manual.
LED
Power
Indicates the status of the power supply
System
Indicates the status of the unit controller and other system parameters.
or
Ethernet Indicates the status of the ethernet port.
RAFT
Remote
Indicates whether a user (Telnet or VT100) is logged in to the unit.
P/N 1200780L1 (AC)/1200781L1 (DC)
ATLAS 830
DESCRIPTION
Not Connected
Receive Data (output)
Transmit Data (input)
Signal Ground
Description
Copyright  2002 ADTRAN, All Rights Reserved
www.adtran.com

Advertisement

loading

Summary of Contents for ADTRAN Atlas 830

  • Page 1: System Status Leds

    None If the terminal has a parallel setting, disable it and use serial. 2. Connect the DB-9 male end of the data cable into the ATLAS 830 C port. Make the connection to the VT100 terminal as appropriate for DMIN your connection.
  • Page 2: Reviewing The Rear Panel Design

    Common connection between external circuitry and NC or NO terminal. Chassis Ground (GND) NAME DESCRIPTION Ground (GND) -48VDC Copyright  2002 ADTRAN, All Rights Reserved www.adtran.com Optional DC Power Supply P/N 1200229L1 CAUTION: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH SAME TYPE AND RATING OF FUSE.