ADTRAN ATLAS 800 SERIES System Manual page 300

ATLAS 800 Series System Manual
Source ID
Min DS0's
Max DS0's
Octal BRI/U: Network Term - Ifce Config
Write security: 3; Read security: 5
This menu allows the user to define option parameters for ports which terminate a BRI connection from the
network. Specifies the configuration parameters for the endpoint.
Switch Type
61200780L1-1C
Simplifies the creation of a dial plan in applications where the criterion for
switching calls to a certain endpoint is a function of which endpoint originated
the call.
• . Zero is the default ID for all endpoints and all accept
D = 0
EFAULT VALUE
numbers. With default values, all calls are routed based only on the dialed
number.
• Multiple endpoints can have the same
• When creating the
C
dialed number or range of dialed numbers to accept.
For example, an application requires that all calls that originate from Port 1 of
the ATLAS 800 Series in Slot 1 be switched to Port 2 of that same module.
Assign a unique
S
OURCE
Port 2 to only accept calls from that unique
Set this to 1 for typical single-call connections. Setting this greater than 1 will
restrict connections to endpoints supporting aggregation (e.g., BONDING) of
the specified number of DS0s.
Set this to 1 for typical single-call connections. Setting this greater than 1 will
accommodate connections to endpoints supporting aggregation (e.g.,
BONDING) of up to the specified number of DS0s. This also sets the number of
DS0s presented in the negotiation of outgoing aggregate calls.
Defines the type of BRI switch to which the port is connected. If connected to
another ATLAS 800 Series, both need to be set to the same switch type. The
following options are available:
N ISDN.
ATIONAL
© 2004 ADTRAN, Inc.
Octal BRI/U: Network Term - Ifce Config
S
OURCE
list, specify a
A
ALL CCEPT
(e.g., 7) to Port 1 of the module, and then configure
ID
S
OURCE
,
L 5E N
UCENT ORTHERN
Dial Plan
ID .
(s) as well as a
S ID
OURCE
ID (7).
, and
DMS 100
300