Warning Commands And Messages; Table 5-16: Rs-232 Warning - Teledyne 9110AH Instruction Manual

TELEDYNE Model 9110AH NO
The T command lists TEST messages. Examples of the T command are:
T LIST
T LIST ALL
T CONVTEMP
T LIST NOX
T NOX

5.7.4 WARNING Commands and Messages

Table 5-16: RS-232 Warning Messages
Name
WSYSRES
WRAMINIT
WSMPFLOW
WOZONEFLOW
WRCELLP
WBOXTEMP
WRCELLT
WCONVTMP
WOBLKTMP
WDCPS
WDYNZERO
WDYNSPAN
WBLKTEMP
WOZONEGEN
WAUTOZERO
WADINS
Whenever a warning message is reported on the analyzer display, if the RS-232 interface is in
the normal mode(i.e. not in quiet mode) the warning message is also sent to the RS-232
Analyzer Operator Manual, 01620, Rev. F
X
Lists test messages currently enabled with T SET
Lists all test messages
Prints the temperature of the converter
Prints NO concentration message
x
Prints concentration message
Message
SYSTEM RESET
RAM INITIALIZED
SAMPLE FLOW WARN
OZONE FLOW WARNING
RCELL PRESS WARNING
BOX TEMP WARNING
RCELL TEMP WARNING
CONV TEMP WARNING
ORIFICE BLK TEMP WARN
DC POWER SUPPLY WARN
CANNOT DYN ZERO
CANNOT DYN SPAN
SAMPLE FLOW ORIFICE
BLOCK TEMP WARNING
OZONE GEN OFF
AZERO WRN XXX.X MV
A/D NOT INSTALLED
5-34
Description
Analyzer was reset/powered on
RAM was erased
Sample flow out of spec.
Ozone flow out of spec.
Rx cell pressure out of spec.
Box temp. out of spec.
Reaction cell temp. out of spec.
Converter temp. out of spec.
Orifice block temp out of spec.
DC Power voltage out of spec.
Dynamic zero cal. out of spec.
Dynamic span cal. out of spec.
Temperature out of spec.
Ozone generator is off
AutoZero reading out of spec.
A/D board not installed or broken