Calibration Commands And Messages; Table 5-17: Rs-232 C - Teledyne 9110AH Instruction Manual

TELEDYNE Model 9110AH NO
interface. These messages are helpful when trying to track down a problem with the analyzer
and for determining whether or not the DAS reports are actually valid. The warning message
format is for example:
W 194:11:03 0000 SAMPLE FLOW WARN
The format of a warning command is W command. Examples of warning commands are:
W LIST
W CLEAR ALL
Individual warnings may be cleared via the front panel or the command line interface. To clear
the sample flow warning shown above the command would be:
W WSMPFLOW

5.7.5 CALIBRATION Commands and Messages

Table 5-17: RS-232 Calibration Messages
Message
START ZERO CALIBRATION
FINISH ZERO CALIBRATION, NO2=xxxxx ppm
START SPAN CALIBRATION
FINISH SPAN CALIBRATION, NO2=xxxxx ppm
START MULTI-POINT CALIBRATION
FINISH MULTI-POINT CALIBRATION
1
Depends on which units are currently selected.
Analyzer Operator Manual, 01620, Rev. F
X
List all current warnings
Clear all current Warnings
5-35
Description
Beginning zero calibration
1
Finished zero calibration
Beginning span calibration
1
Finished span calibration
Beginning multi-point calibration
Finished multi-point cal.