Table of Contents
Advertisement
TELEDYNE Model 9110AH NO
4 THE M9110AH NO
4.1 Principle of Operation
The TELEDYNE Model 9110AH Analyzer is designed to measure the concentration of nitric
oxide [NO], total oxides of nitrogen [NO
the proper setup, it can operate in any of three sampling modes.
Table 4-1: Sampling Modes of the M9110AH
Mode
NO/NO
switching mode
X
NO only mode
NO
only mode
x
Regardless of which sampling mode the instrument is operating in, the signal from the
M9110AH comes from the light emitted from the chemiluminescent gas phase reaction of nitric
oxide [NO] and ozone [O
NO
O
NO
+
¾
¾ ®
3
NO
*
NO
¾
¾ ®
2
The reaction of NO with ozone results in electronically excited NO
first equation above. The excited NO
photon and dropping to a lower energy level as shown in the second equation. It has been
shown that the light intensity produced is directly proportional to the [NO] concentration
present.
In the NO mode, the sample gas is routed directly into the reaction cell. Any NO gas present
reacts with ozone, producing light as described above.
In the NO
mode, the sample gas is routed through a NO
x
present is reduced to NO. The NO initially present remains as NO, therefore the signal is the
sum of NO and NO
Analyzer Operator Manual, 01620, Rev. F
X
X
Description
Converter is switched, measures NO, NO
Converter is switched out of sample stream. Nitric Oxide is only gas
measured.
Converter is switched into the sample stream, NO
measured.
] as follows:
3
*
O
+
2
2
hv
+
2
molecules release their excess energy by emitting a
2
present in the sample gas stream.
2
ANALYZER
] and, by calculation, nitrogen dioxide [NO
x
to NO converter, and any NO
2
4-1
]. With
2
, and NO
x
2
is only gas
x
molecules as shown in the
2
2
Advertisement
Chapters
Table of Contents
Troubleshooting
