Password Enable; Time Of Day Clock; Diagnostic Mode; Communications Menu - Teledyne 9110AH Instruction Manual

TELEDYNE Model 9110AH NO

5.3.5 Password Enable

If passwords are enabled, one of the values shown in Table 5-6 are required to calibrate or
setup the instrument. If the 512 password is known, only calibrations can be performed. If the
818 password is known, the SETUP mode can be accessed. The 101 password can be used to
enter both calibration and SETUP menus. A list of passwords is in Table 5-6.
Table 5-6: Calibrate, Setup Passwords
Password Usage
Calibration Password
Setup Password

5.3.6 Time of Day Clock

The instrument has an internal time of day clock. The time of day can be set by pressing
SETUP-CLOCK-TIME and entering the time in 24hr format. In a similar manner the date can
be entered by pressing SETUP-CLOCK-DATE and entering the date in a dd-mmm-yy format. If
you are having trouble with the clock running slow or fast, the speed of the clock can be
adjusted by selecting the CLOCK_ADJ variable in the SETUP-MORE-VARS menu.

5.3.7 Diagnostic Mode

The M9110AH Diagnostic Mode allows additional tests and calibrations of the instrument.
These features are separate from the TEST functions because each DIAG function has the
ability to alter or disable the output of the instrument. While in DIAG mode no data is placed in
the DAS averages. Details on the use of Diagnostic mode are in Section 9.1.3.

5.3.8 Communications Menu

The COMM menu allows the RS-232 BAUD rate to be set. To set the BAUD rate press SETUP-
MORE-COMM-BAUD, select the appropriate BAUD rate, then press ENTR.
The instrument ID number can also be set. This ID number is attached to every RS-232
message sent by the M9110AH. To set the ID press SETUP-MORE-COMM-ID and enter a 4
digit number from 0000-9999, then press ENTR. There are more RS-232 setups in the VARS
menu Section 5.3.9.
Analyzer Operator Manual, 01620, Rev. F
X
Use to get into CAL menus
Use to get into SETUP menus
5-21
Password
512, 101
818, 101