Snmp Host Table - D-Link DES-3526 - Switch - Stackable User Manual

xStack
To configure SNMP Community entries, open the SNMP Manager folder, located in the Security Management folder, and click
the SNMP Community Table link, which will open the following window:
The following parameters can set:
Parameter
Community Name
View Name
Access Right
To implement the new settings, click Apply. To delete an entry from the SNMP Community Table, click the
heading, corresponding to the entry you wish to delete.

SNMP Host Table

Use the SNMP Host Table window to set up SNMP trap recipients.
To open this window click, Security Management > SNMP Manager > SNMP Host Table.
To delete an existing SNMP Host Table entry, click the corresponding
To display the current settings for an existing SNMP Host Table entry, click the blue link for the entry under the Host IP Address
heading.
To add a new entry to the Switch's SNMP Host Table, click the Add button in the upper left-hand corner of the window. This will
open the SNMP Host Table Configuration window, as shown below.
®
DES-3500 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
Figure 7- 52. SNMP Community Table Configuration window
Description
Type an alphanumeric string of up to 32 characters that is used to identify members of an
SNMP community. This string is used like a password to give remote SNMP managers
access to MIB objects in the Switch's SNMP agent.
Type an alphanumeric string of up to 32 characters that is used to identify the group of MIB
objects that a remote SNMP manager is allowed to access on the Switch. The view name
must exist in the SNMP View Table.
Read Only - Specifies that SNMP community members using the community string created
can only read the contents of the MIBs on the Switch.
Read Write - Specifies that SNMP community members using the community string created
can read from, and write to the contents of the MIBs on the Switch.
Figure 7- 53. SNMP Host Table window
button under the Delete heading.
193
under the Delete