Config Firmware Image - D-Link DES-3526 - Switch - Stackable User Manual

xStack
Version States the firmware version.
Size States the size of the corresponding firmware, in bytes.
Update Time States the specific time the firmware version was downloaded to the Switch.
From States the IP address of the origin of the firmware. There are five ways firmware may be
downloaded to the Switch.
User States the user who downloaded the firmware. This field may read "Anonymous" or "Unknown"
for users that are not identified.

Config Firmware Image

The Config Firmware Image window allows users to configure firmware images saved in the memory of the Switch. To access
the following window, click Maintenance > Multiple Image Services > Config Firmware Image.
This window offers the following information:
Parameter
Image Select the firmware image to be configured using the pull-down menu. The Switch allows two
firmware images to be stored in the Switch's memory.
Action This field has two options for configuration.
•
•
Click Apply to implement changes made.
®
DES-3500 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
R – If the IP address has this letter attached to it, it denotes a firmware upgrade
•
through the Console Serial Port (RS-232).
T - If the IP address has this letter attached to it, it denotes a firmware upgrade through
•
Telnet.
S - If the IP address has this letter attached to it, it denotes a firmware upgrade through
•
the Simple Network Management Protocol (SNMP).
W - If the IP address has this letter attached to it, it denotes a firmware upgrade
•
through the web-based management interface.
SIM – If the IP address has this letter attached to it, it denotes a firmware upgrade
•
through the Single IP Management feature.
Figure 9- 6. Config Firmware Image window
Description
Delete – Select this option to delete the firmware image specified in the Image field above.
Boot – Select this option to set the firmware image specified above as the boot up
firmware for the Switch. This firmware will be set as the boot up firmware after a switch
reboot has been performed. The default setting has firmware image ID 1 as the boot up
firmware image for the Switch unless specified here.
232