Snmp Host Table - D-Link DGS-3427 User Manual

SNMP Host Table

Use the SNMP Host Table window to set up SNMP trap recipients. Open the SNMP Manager folder, (located in the
Adminstation folder) and click on the SNMP Host Table link. This will open the SNMP Host Table window, as shown
below. To delete an existing SNMP Host Table entry, click the corresponding X under the Delete heading. To display the
current settings for an existing SNMP Group Table entry, click the blue link for the entry under the Host IP Address
heading.
To add a new entry to the Switch's SNMP Host Table, click the Add button in the upper left-hand corner of the window.
This will open the SNMP Host Table Configuration window, as shown below.
The following parameters can set:
Parameter
Host IP Address
SNMP Version
Community String or SNMP
V3 User Name
To implement your new settings, click Apply. To return to the SNMP Host Table, click the
Entries link.
xStack DGS-3400 Series Fast Ethernet Switch
Figure 6- 41. SNMP Host Table window
Figure 6- 42. SNMP Host Table Configuration window
Description
Type the IP address of the remote management station that will serve as the
SNMP host for the Switch.
V1 - To specifies that SNMP version 1 will be used.
V2 - To specify that SNMP version 2 will be used.
V3-NoAuth-NoPriv - To specify that the SNMP version 3 will be used, with a
NoAuth-NoPriv security level.
V3-Auth-NoPriv - To specify that the SNMP version 3 will be used, with an
Auth-NoPriv security level.
V3-Auth-Priv - To specify that the SNMP version 3 will be used, with an Auth-
Priv security level.
Type in the community string or SNMP V3 user name as appropriate.
64
Show All SNMP Host Table