Ip-Mac Binding Table - D-Link DES-3526 - Switch - Stackable User Manual

xStack

IP-MAC Binding Table

The window shown below can be used to create IP-MAC binding entries. Enter the IP and MAC addresses of the authorized users
in the appropriate fields and click Add. To modify either the IP address or the MAC address of the binding entry, make the
desired changes in the appropriate field and Click Modify. To find an IP-MAC binding entry, enter the IP and MAC addresses
and click Find. To delete an entry click Delete. To clear all the entries from the table click Delete All. To view this window click,
Configuration > IP-MAC Binding > IP-MAC Binding Table.
The following fields can be set or modified:
Parameter
IP Address
MAC Address
All Ports
Ports
Mode
®
DES-3500 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
Figure 6- 106. IP-MAC Binding Table window
Description
Enter the IP address you wish to bind to the MAC address set below.
Enter the MAC address you wish to bind to the IP Address set above.
Click this check box to configure this IP-MAC binding entry (IP Address + MAC Address) for all
ports on the Switch.
Specify the switch ports for which to configure this IP-MAC binding entry (IP Address + MAC
Address).
The user may set the IP-MAC Binding Mode here by using the pull-down menu. The choices
are:
ARP – Choosing this selection will set a normal IP-Mac Binding entry for the IP address and
MAC address entered.
ACL – Choosing this entry will allow only packets from the source IP-MAC binding entry
created here. All other packets with a different IP address will be discarded by the Switch. This
mode can only be used if the ACL Mode has been enabled in the IP-MAC Binding Ports
window as seen previously.
127