Table of Contents
Advertisement
2. Select the configuration option set to be copied
into the Edit area by using the appropriate
function key. Use the scroll keys, if necessary.
Load from:
Activ
F1
3. Press F1 to select Edit.
Choose Funct:
Edit
F1
4. Press the
key from the Edit screen to display
the SNMP selection.
Edit:
DTE
F1
5. Press F3 to select SNMP.
Edit:
User
F1
6. Press F1 to select Gen from the SNMP Config
screen.
SNMP Config:
Gen
F1
3160-A2-GB22-10
Cust
Fact1
F2
F3
Save
F2
F3
Port
NET
F3
F2
Alarm
SNMP
F2
F3
Trap
F2
F3
December 1996
7. Press the F1 (Next) key until the Modem Link
configuration option appears.
System Name:
Next
F1
8. Press F2 (PPP) or F3 (SLIP).
Modem Link:
Next
F1
Differences Using the Async Terminal: To set the Link
Layer Protocol, select Modem & Communication Port
Options from the main/configuration/edit/snmp menu.
(See Figure 3-22 for an example of the screen that
appears.)
Specifying the Community Name(s) and
Access Type(s)
You have the capability of specifying up to two
community names (community name 1 and community
name 2) to be used by external SNMP managers when
trying to access objects in the DSU/CSU's MIB. Once you
specify the community name(s), you must then specify the
type of access to the MIB that SNMP managers in the
community are permitted to have.
To specify the community name 1 and its access type,
1. Press F3 to select Cnfig from the top-level menu
screen.
DSU ESF
Stat
F1
Operation
Edit
Clear
F2
F3
PPP
SLIP
F3
F2
Test
Cnfig
F3
F2
3-29
Advertisement
Chapters
Table of Contents
Troubleshooting
