Edit User Screen; Setting The Ip Address - Paradyne ACCULINK 316x Operator's Manual

ACCULINK 316x DSU/CSU
3. Press F1 to select Edit.
Choose Funct:
Edit
F1
4. Press the key from the Edit screen to display
the User selection.
Edit:
DTE
F1
5. Press F3 to select User.
Edit:
Chan
F1
6. Press the F1 (Next) key until the Com Use
configuration option appears.
Self-Test:Enab
Next
F1
7. Press F2 to configure the COM port as the
management link to an external SNMP manager.
Com Use:
Next
F1
3-26
Save
F2 F3
Port NET
F3
F2
Gen User
F2 F3
Enab Disab
F2 F3
SNMP ASCII
F2 F3
December 1996
Differences Using the Async Terminal: To select the
port to be used for SNMP communications, use the
main/configuration/edit/user screen to set the Use field to
SNMP for the appropriate port type. Figure 3-21 shows
an example of this screen.
Customer ID: New Cust
Self Test: _____
Front Panel Access: _____
Front Panel Pass-Through: _____
Dial-In Access: _____
Password Mode: _____
Communications Port
Use: _____
Type: _____
Rate: _____
Character Length: _____
Parity: _____
Stop Bits: _____
Save Edit Main
Figure 3-21. Edit User Screen

Setting the IP Address

The IP address is the address used by the SNMP
manager to access the device. For devices using PPP, the
IP address can be negotiated, if the network device, e.g.,
router or SNMP manager, supports such negotiation. The
IP address is composed of four fields with three digits per
field (xxx.xxx.xxx.xxx).
The IP address is set for either the COM port or the
MODEM port, depending on which one has been chosen
as the SNMP communications link. The example below
assumes that an IP address of 010.155.111.222 is being set
for the MODEM port. You can use the same principles to
assign any value (between 000 and 255 for each digit
field) to either port.
main/configuration/edit/user
Model: ACCULINK XXXX
User
Modem Port
Use: _____
Type: _____
Rate: _____
Character Length: _____
Parity: _____
Stop Bits: _____
Long Space Disconnect: _____
Previous Cntrl–x to Disconnect
3160-A2-GB22-10