Configuring An Ip Address For Snmp Trap Manager; Trap Options Screen - Paradyne ACCULINK 316x Operator's Manual

Model: ACCULINK XXXX
Customer ID: New Cust
Trap Options
Number of Trap Managers: 6
Trap Manager 1 IP Address:
Trap Manager 2 IP Address:
Trap Manager 3 IP Address:
Trap Manager 4 IP Address:
Trap Manager 5 IP Address:
Trap Manager 6 IP Address:
General Traps: _____
Enterprise Specific Traps: _____
Link Traps: _____
Link Trap Interfaces: _____
Save Edit Main
Figure 3-23. Trap Options Screen
Configuring an IP Address for SNMP Trap
Manager
An IP address must be configured for each SNMP trap
manager specified. This configuration option is displayed
for the number of trap managers specified by the Number
of Trap Managers configuration option.
To configure an IP address for the SNMP trap
manager:
1. Press F3 to select Cnfig from the top-level menu
screen.
DSU ESF
Stat
F1
2. Select the configuration option set to be copied
into the Edit area by using the appropriate
function key. Use the scroll keys, if necessary.
Load from:
Activ
F1
3160-A2-GB22-10
main/configuration/edit/snmp/traps
000 000 000 000 . . . Clear
. . .
Clear
. . .
Clear
. . . Clear
. . . Clear
. . .
Clear
Both
Enable
Both
Both
Previous Cntrl–x to Disconnect
Test Cnfig
F2 F3
Cust Fact1
F3
F2
December 1996
3. Press F1 to select Edit.
Choose Funct:
Edit Save
F1
4. Press the key from the Edit screen to display
the SNMP selection.
Edit:
DTE Port
F1
5. Press F3 to select SNMP.
Edit:
User Alarm
F1
6. Press F2 to select Trap from the SNMP Config
screen.
SNMP Config:
Gen Trap
F1
7. Press the F1 (Next) key until the Trap n IP
Address configuration option appears.
Num Trap Mgrs:1
Next 1
F1
Operation
F2 F3
NET
F3
F2
SNMP
F2 F3
F2 F3
2
F2 F3
3-33