Paradyne ACCULINK 316x Operator's Manual page 21

Connector Name
POWER
AUX PORT
COM PORT
MODEM
DTE (DSX-1)
NETWORK
CLOCK IN
PORT 1— 4
3160-A2-GB22-10
Table 1-1
Models 3160/3164 DSU/CSUs Rear Panel Connectors
A modular connector that supplies power to the DSU/CSU.
An auxiliary communications port for future use.
A communications port that provides access to the front panel from a locally
connected PC. The port can also be used to connect a terminal for an async
terminal interface, an ASCII terminal or printer for reporting alarm messages, or to
support an SNMP management link. The connector is an 8-pin, keyed modular jack.
An RJ11 connector for a 2-wire VF line used to connect the integral modem.
Provides access to the front panel from a remotely connected PC. The port can also
be used to connect a remote terminal for an async terminal interface or an ASCII
terminal or printer for reporting alarm messages, or to support an SNMP
management link.
A DB15 socket, screw-type connector for DTE equipment.
An RJ48C, unkeyed modular jack that provides connection to the T1 network.
A connector used to attach an external clock to the DSU/CSU.
A DB25 (EIA 530A) connector used to connect the customer's synchronous data
DTE.
December 1996
Function
Introduction
1-7