Starting Front Panel Emulation; Deactivating The Alarm Relay - Paradyne ACCULINK 316x Operator's Manual

Deactivating the Alarm Relay

The Alarm Cut-off command forces a deactivation of
the alarm relay on the 3000 Series Carrier during an alarm
condition. Since this function only affects the 3000 Series
Carrier, it is only available for Model 3161 DSU/CSUs.
The alarm relay function must first be enabled by the
Alarm Relay configuration option (see Appendix C,
Configuration Options).
To deactivate the alarm relay,
1. Press the key from the top-level menu screen
to bring the Ctrl branch onto the front panel LCD.
DSU ESF
Stat
F1
2. Press F3 to select Ctrl from the top-level menu
screen.
DSU ESF
Test
F1
3. From the Control screen, press F1 to select ACO.
Control:
ACO
F1
4. The Command Complete screen appears.
Alarm Cut-Off:
Command Complete
F1
3160-A2-GB22-10
Test Cnfig
F2 F3
Cnfig Ctrl
F2 F3
Rel LED
F3
F2
F2 F3
December 1996
Starting Front Panel
Emulation
The front panel emulation function enables you to
display the front panel of a specified near-end or far-end
316x DSU/CSU on a PC. If the DSU/CSU selected is not
locally attached to the PC, you must first dial to the
remote DSU/CSU before starting front panel emulation.
To start front panel emulation,
1. From the PC, open Program Manager from
Windows.
2. The Front Panel window opens.
NOTE
The modem attached to the PC
must support AT commands for
the Front Panel Emulation
software to successfully place the
call.
Operation
3-69