Snmp Community Access Configuration; Figure 4-6 Snmp Community Access Configuration Screen - Paradyne NP 64 Plus User Manual

SNMP Community
Access
Configuration

********************** SNMP Community Access Configuration *********************

Name: F@43802
Comm #1 Access [A1=]
1) Read Only
>>2) Read/Write<<
3) None
Comm #4 Access [A4=]
1) Read Only
>>2) Read/Write<<
3) None
NOTE: Each Name entry must be made individually.
Help[?]
>
980-001-0221C
March 2001
The SNMP Community Access Configuration screen allows you to view and alter pa-
rameters for SNMP Community operations.
The SNMP Community Access Configuration screen is shown in Figure 4-6.
Community #1 Name [C1=]: public
Community #2 Name [C2=]:
Community #3 Name [C3=]:
Community #4 Name [C4=]:
Community #5 Name [C5=]:
Community #6 Name [C6=]:
Comm #2 Access [A2=]
1) Read Only
>>2) Read/Write<<
3) None
Comm #5 Access [A5=]
1) Read Only
>>2) Read/Write<<
3) None
Save[SA] Cancel[X]

Figure 4-6 SNMP Community Access Configuration Screen

1. Community # n (1-6) Name - Community names to which the unit belongs.
These commands [Cn] must be entered individually, not with other fields.
2. Comm # n (1-6) Access - Setting for Read/Write access in each of the
communities.
NOTE: Settings may only be changed after login with Supervisor password.
Default values for these settings are as shown in Figure 4-6.
Commands
Help [?] - Advances to "Help" for SNMP Community Access Configuration screen.
Save [SA] - Saves parameters and returns to System View screen.
Cancel [X] - Returns to System View screen without saving changes.
Save the SNMP Community Configuration changes when they are all set correctly by
entering "SA" followed by ENTER. This will also return the user to the System View
screen.
Proceed to Trap Configuration, selecting [TC] by typing "TC" followed by ENTER.
FrameSaver NP 64+ User's Manual - Installation Guide
4 Operation
Comm #3 Access [A3=]
1) Read Only
>>2) Read/Write<<
3) None
Comm #6 Access [A6=]
1) Read Only
>>2) Read/Write<<
3) None
4-17