Selecting A Model 3161 Dsu/Csu; Dsu/Csu Identity; Health And Status Results Screen - Paradyne ACCULINK 316x Operator's Manual

ACCULINK 316x DSU/CSU
Differences Using the Async Terminal: To monitor the
self-test from the async terminal, select Health, Test
Status, and Self Test Results from the main/status menu.
The full screen display capacity provides a complete test
results screen that includes the self-test results.
Figure 2-10 shows an example of this screen.
Customer ID: New Cust
Health and Status Self Test Results
DSU Operational CPU fail
LOS at Net Device fail
LOS at DTE B8ZS/LOS fail
OOF at Net Modem fail
OOF at DTE DTE T1 fail
AIS at Net Alarm fail
AIS at DTE LCD fail
EER at Net NET T1 fail
Yellow at Net Memory fail
Yellow at DTE DSU fail
Master Clock Fail DSU Port 1 fail
SNMP Link Down DSU Port 2 fail
Selftest failed DSU Port 3 fail
DevFail yyyyyyyy DSU Port 4 fail
Download failed Unknown Exp Dev
Alm Retry Disab Failure xxxxxxxx
Test in progress Passed
Modem Connected
Refresh Down UP Main Previous Cntrl–x to Disconnect
Figure 2-10. Health and Status Results Screen
If a test fails, fail appears next to the component
reporting the failure.
To perform a power or reset of the device, see
Resetting the CSU/DSU in Chapter 4.
Selecting a Model 3161
DSU/CSU
Use the SDCP when accessing a specific circuit card
installed in the 3000 Series Carrier.
To access a 3161 DSU/CSU,
1. Press Select on the SDCP.
2. Enter a valid carrier and slot address. The green
OK indicator on the selected 3161 DSU/CSU
should flash. (It should be the only OK indicator
flashing in the cabinet.)
3. Press Select again. The display on the SDCP
should show the last menu item displayed, or in
the case of a new installation, the top-level menu
on the selected circuit card.
2-10
main/status/health_and_status
Model: ACCULINK XXXX
Test Status
No Test Active
LLB Test Active
PLB Test Active
DLB Test Active
RLB Test Active
DCLB on Port n
DTLB on Port n
QRSS Test Active
1–8 Test Active
QRSS on Port n
511 on Port n
Monitoring QRSS
Monitoring QRSS, Port n
Monitoring 511, Port n
DLB Test, Extrn
Lamp Test Active

DSU/CSU Identity

The identity of the 316x DSU/CSU (serial number,
model number, software revision level, hardware revision
level, and customer ID) is available through the Status
branch of the front panel menu (see Appendix A, Front
Panel Menu).
The customer ID is the only identity number you can
change.
To display the DSU/CSU's identity,
1. Press F1 to select Status from the top-level menu
screen.
2. Press the
to bring the ID selection onto the front panel LCD.
3. Press F3 to select ID from the Status screen.
December 1996
DSU ESF
Stat Test Cnfig
F1 F2 F3
key three times on the Status screen
Status:
DevHS STest Perf
F3
F1 F2
Status:
TStat LED ID
F3
F1 F2
3160-A2-GB22-10