Starting A Data Channel Loopback - Paradyne ACCULINK 316x Operator's Manual

4. Press F3 to select RLB.
Loopback:
PLB
F1
Test Started appears on Line 2. If a Repeater
loopback is already in progress, the Already
Active message appears. If an invalid combination
of loopbacks is in progress, the error message
Invalid Test Combo appears (see Table4-2 for
valid loopback test combinations).

Starting a Data Channel Loopback

The Data Channel loopback command (DCLB) loops
the data received from the network interface, for all DS0
channels allocated to the selected port, back to the
network. The loopback occurs after the data passes
through the port circuitry but before it is sent out the data
port.
To perform a Data Channel loopback,
1. Press F2 to select Test from the top-level menu
screen.
DSU ESF
Stat
F1
3160-A2-GB22-10
DLB RLB
F2 F3
Test Cnfig
F2 F3
December 1996
2. From the Test screen, press F2 to select Lpbk.
Test:
Rlpbk Lpbk
F1
3. From the Loopback screen, press
to display the DCLB selection on the screen.
Loopback:
Abort LLB
F1
4. Press F3 to select DCLB.
Loopback:
DLB RLB
F1
5. From the DCLB screen, press the function key for
the port for which you want to perform the data
channel loopback. Use the scroll keys, if
necessary.
Loopback: DCLB
Prt1 Prt2
F1
Test Started appears on Line 2. If a Data Channel
loopback is already in progress, the Already
Active message appears. If an invalid combination
of loopbacks is in progress, the error message
Invalid Test Combo appears (see Table 4-2 for
valid loopback test combinations).
Maintenance
Ptrns
F2 F3
three times
PLB
F2 F3
DCLB
F2 F3
Prt3
F3
F2
4-9