Entering A Password To Gain Access; Call Setup Screen - Paradyne ACCULINK 316x Operator's Manual

6. When the number of the desired directory appears
on the screen, press F3 (Dial) to place the call.
Differences Using the Async Terminal: To initiate a call
at the local DSU/CSU, select Call Setup from the
main/control menu. Figure 3-40 shows an example of the
screen that appears.
Customer ID: New Cust
Call Setup
Directory Number: _____
Directory Phone Number:
Dial
Main
Figure 3-40. Call Setup Screen
Enter the number for the phone directory and select
Dial.

Entering a Password to Gain Access

You are prompted to enter a password (up to
8 characters) when you are dialing in to a device whose
Set Password User Interface configuration option is set
(see Appendix C, Configuration Options). The Password
function is not available for Model 3161 DSU/CSUs since
passwords are only used for modem connections and an
integral modem is not available for 3161 DSU/CSUs.
Valid password characters are 0–9, a–z, A–Z, #, -, .,
and /. The existing password is not shown on the screen.
An underscore in the first position shows where to enter
the first character. If the password is set to all null
characters (default value), press F3 (Done) when the
password screen first appears.
Create and modify passwords with the Password
command in the Control branch of the front panel menu
tree (see Chapter 2, Installation, for information about
creating/modifying a password).
3160-A2-GB22-10
main/control/call_setup
Model: ACCULINK XXXX
Previous Cntrl–x to Disconnect
December 1996
The following screen appears when you call a
DSU/CSU that has a password enabled.
Passwd:
Up Down
F1 F2
To complete a call when the remote DSU/CSU Set
Password configuration option is enabled,
1. Use the and
under the desired character. You must enter a
character before the
the next space to the right. The
destructive.
Passwd:
Up
F1
2. Enter the required password. Press F1 (Up) and F2
(Down) to scroll up and down through the valid
characters/numbers for the password. You have
five minutes to enter the correct password before
the DSU/CSU disconnects and ends the session.
3. Press F3 (Done) to indicate you are done entering
the password. If you enter an invalid password, the
message Invalid Password appears and the call
disconnects.
Passwd:
Up
F1
Differences Using the Async Terminal: See Entering a
Password in the Using the Async Terminal Feature section
for a description of the password sequence when using the
async terminal.
Operation
Done
F3
keys to position the cursor
key moves the cursor to
key is not
Down Done
F3
F2
Down Done
F3
F2
3-65