Aborting Test Patterns; Lamp Test; Starting A Lamp Test - Paradyne ACCULINK 316x Operator's Manual

ACCULINK 316x DSU/CSU

Aborting Test Patterns

Use the Abort command to stop all test patterns or any
selected test pattern active on the DSU/CSU.
To abort test patterns,
1. Press F2 to select Test from the top-level menu
screen.
DSU ESF
Stat
F1
2. From the Test screen, press F3 to select Ptrns.
Test:
Rlpbk Lpbk
F1
3. From the Patterns screen, press F1 to select Abort.
Patterns:
Abort
F1
4. From the Patterns Abort screen, press the desired
function key to abort either All active test patterns,
active Send test patterns, or the active Monitor
(Mon) test pattern.
Patterns: Abort
All
F1
If you select All, the DSU/CSU terminates all
active test patterns and displays the message
Command Complete. Skip Step 5.
4-14
Test Cnfig
F3
F2
Ptrns
F3
F2
Send Mon
F3
F2
Send Mon
F2 F3
December 1996
NOTE
Be careful when selecting a specific
test pattern to abort. If you mistakenly
choose to abort a test pattern that is
not currently running, a Command
Complete message still displays and
the test pattern currently active still
runs. You can use the TStat branch of
the menu to view the test status to
determine if the abort was successful.
5. From the Abort screen, press the function key that
corresponds to the network or port for which you
want to abort a test pattern. Use the scroll keys, if
necessary.
Abort: Send or Mon
NET
F1
The DSU/CSU terminates the selected test pattern
and displays the message Command Complete.

Lamp Test

Use the Lamp Test commands to start and stop a test of
the DSU/CSU front panel LEDs. This feature is only
available from the front panel.

Starting a Lamp Test

To start a Lamp test,
1. Press F2 to select Test from the top-level menu
screen.
DSU ESF
Stat
F1
Prt1 Prt2
F2 F3
Test Cnfig
F3
F2
3160-A2-GB22-10