Verifying That Self-Test Passed; Setting The System Clock; Assigning The Node Ip Address - Paradyne iMarc SLV 9820-2M Installation Instructions Manual

Verifying that Self-Test Passed

Procedure
1. Follow this menu selection sequence from the Main Menu and press Enter after
each selection:
Main Menu → Status → System and Test Status
2. Check the Self-Test Results column (in the center of the System and Test Status
screen).
— If Passed appears, the iMarc unit successfully completed the self-test.
— If any failure messages appear in this column, reset the unit by disconnecting,
then reconnecting the power cord. The unit will perform the self-test again.
If the failure reappears, call your service representative for assistance.

Setting the System Clock

Procedure
To set up the system clock:
1. Select System Information.
Main Menu → Control → System Information
2. Move the cursor to the Date, then the Time field to enter:
— Date in the mm/dd/yyyy format (month/day/year)
— Time in the hh:mm:ss format (hours:minutes:seconds)
3. Save the settings.

Assigning the Node IP Address

Procedure
1. Set up the node.
Main Menu → Configuration → Management and Communication → Node IP
2. Minimally, enter the following options:
— Node IP Address
— Node Subnet Mask
3. Save the configuration.
13