Setting The Trace Level; Setting The Error Log File Size - Hitachi XP P9500 User Manual

>dlnkmgr set -ellv 2
Specify the error log collection level as a number.

Setting the Trace Level

You can set up the trace level for a trace file hdlmtrn.log (n indicates a file
number from 1 to 64).
Table 3-17 Values for the Trace Level Setting on page 3-75
describes the possible values for the trace level setting.
0
1
2
3
4
If an error occurs, you might have to set the trace level to 1 or higher to
collect any trace information.
The higher this value is set, the more information that will be output. As the
amount of trace information to be output increases, it will take less time to
overwrite the old trace information with the new information.
For normal operation, we recommend that you set the trace level to 0. If you
set the trace level to a value higher than necessary, HDLM performance
might decrease, or trace information required to analyze the cause of an
error might be overwritten.
• Setting up the trace level by using the set operation
The following is an example of setting up the trace level by using a
command:
>dlnkmgr set -systflv 1
Specify the trace level as a number.

Setting the Error Log File Size

There are two error logs: the HDLM manager log file dlmmgrn.log (n
indicates a file number from 1 to 16) and the HDLM GUI log file dlmguin.log
(n indicates a file number of 1 or 2).
You can specify a value (in kilobytes) from 100 to 2000000 for the error log
file size. For HDLM GUI logs, file sizes range from 100 to 9900. If you specify
Table 3-17 Values for the Trace Level Setting
Value
No trace is output.
Only error information is output.
Program operation summaries are output.
Program operation details are output.
All information is output.
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Windows(R))
lists and
Description
3-75