Setting The Error Log Collection Level - Hitachi XP P9500 User Manual

Values in the set
operation
• Setting up LU deletion by using the set operation
The following is an example of setting up LU deletion by using a
command:
>dlnkmgr set -rmlu on -force
To enable the LU deletion function, specify on. To disable the LU deletion
function, specify off. If you specify on, you can set the conditions for the
-force parameter.

Setting the Error Log Collection Level

There are two error logs: the HDLM manager log file dlmmgrn.log (n
indicates a file number from 1 to 16) and the HDLM GUI log file dlmguin.log
(n indicates a file number of 1 or 2).
Table 3-16 Values for the Error Log Collection Level Setting on page 3-74
lists and describes the values for the error log collection level setting.
0
1
2
3
4
If an error occurs, you might have to change the collection level to 1 or
higher to collect any log information.
The higher this value is set, the more information that will be output. As the
amount of log information to be output increases, it will take less time to
overwrite the old error log information with the new information.
• Setting up the error log collection level by using the set operation
The following is an example of setting up the error log collection level by
using a command:
3-74
The removed LU is restored after it is recovered from the physical
failure and the disk is re-scanned.
Table 3-16 Values for the Error Log Collection Level Setting
Value
No error logs are collected.
All information for errors of the "Error" level or higher is
collected.
All information for errors of the "Warning" level or higher is
collected.
All information for errors of the "Information" level or higher
is collected.
All information for errors of the "Information" level or higher
(including maintenance information) is collected.
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Windows(R))
Description
Description