Hitachi XP P9500 User Manual page 105

HDLM 5.5 or later has been installed, the KAPL09173-W message will
appear. If this happens, carry out the procedure shown in
Installation or Re-installation of HDLM on page
appears, go to step 6.
If you are planning to perform an unattended installation, execute the
¢
installhdlm utility.
At the command prompt, execute the following command:
drive-to-which-the-installation-DVD-is-inserted:\HDLM_Windows
\DLMTools\installhdlm -f installation-information-settings-
file
Specify n for the restart key in the installation-information settings
file.
This command checks whether HDLM has already been installed. If
HDLM 5.4 or earlier has been installed, the KAPL09129-E message will
appear. If this happens, carry out the procedure shown in
from HDLM 5.4 or Earlier to HDLM 5.5 or Later on page
HDLM 5.5 or later has been installed, the KAPL09183-E message will
appear, and then the upgrade installation or re-installation will be
performed.
After the installation is complete, go to step 13.
6 The program checks the MPIO driver version, and then installs the MPIO
.
driver. If a message appears asking you whether you want to install the
MPIO driver, make sure that no multi-path management software other
than HDLM is installed.
If multi-path management software other than HDLM is installed, click
¢
the Cancel button to cancel the installation, uninstall the multi-path
management software, and then install HDLM.
If no multi-path management software other than HDLM is installed,
¢
click the Next button to continue the installation.
7 Specify a license key file or enter a license key by following the
.
instructions shown in the messages that appear in the window.
If a license key file was saved in step 4, specify that license key file.
¢
If a license key file is not being used, specify the license key directly.
¢
8 Specify the installation folder by following the instructions shown in the
.
messages that appear in the window.
The utility for registering HDLM persistent reservation keys (dlmprsvkey)
will be automatically executed. However, creation of the PRSV key might
be unsuccessful if, for example, an NIC does not exist. If the PRSV key is
created with time information only, or if key creation fails, a dialog box
will prompt you to enter the PRSV key.
If this dialog box appears, go to step 9; otherwise, go to step 11.
9 Enter the PRSV key by following the instructions shown in the dialog box.
.
The PRSV key is required for the HDLM functions to properly operate.
Also, the value of the PRSV key must be unique for each host.
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Windows(R))
Upgrade
3-63. If no message
Migrating
3-64. If
3-39