The Dlmchkpath Utility For Checking Hdlm Paths - Hitachi XP P9500 User Manual
Hitachi dynamic link manager software user guide for windows (6.6) (hit5201-96006, november 2011)
Hide thumbs
Also See for XP P9500:
- User manual (746 pages) ,
- User manual (450 pages) ,
- User manual (188 pages)
Table of Contents
Advertisement
-s
-v
Specify this parameter to display the registered PRSV key.
Example
-h
Displays the format of the dlmprsvkey utility.
If you do not specify any parameters, a warning message will appear.
The dlmchkpath Utility for Checking HDLM Paths
If you install or uninstall HDLM in a multi-path configuration, the disk might
become corrupted. Use the dlmchkpath utility to check HDLM paths and to
make sure that the system is in a single-path configuration. During an
upgrade installation, a re-installation, or uninstallation of HDLM, the
dlmchkpath utility is executed automatically. If the system is in a single-path
configuration, the dlmchkpath utility displays nothing during an upgrade
installation, a re-installation, or uninstallation of HDLM. A warning dialog box
will appear if the system is in a multi-path configuration.
However, when you use one of the following methods of installing HDLM and
the system is determined to be a multi-path configuration, the installation will
terminate without displaying any warning dialog boxes:
•
Upgrade installation using the unattended installation
•
Re-installation using the unattended installation
When the dlmchkpath utility is executed manually, a message will appear as
shown in the execution example in
located in the following location:
HDLM-installation-folder\bin
KAPL12106-I
An attempt to register the PRSV key was
successful. (PRSV key = 0123456789abcdef)
In the following example, the utility registers the PRSV key by
specifying it on the host:
>dlmprsvkey -r 0123456789ABCDEF
KAPL12104-I
The operation for PRSV key registration will now
start. Is this OK? [y/n]: y
KAPL12106-I
An attempt to register the PRSV key was
successful. (PRSV key = 0123456789abcdef)
Specify this parameter to avoid displaying a confirmation message
upon execution of the dlmprsvkey utility.
>dlmprsvkey -v
KAPL12116-I
The registered PRSV key will now be displayed.
(PRSV key = 0123456789abcdef)
Utility Reference
Hitachi Dynamic Link Manager User Guide (for Windows(R))
Parameters on page
7-14. This utility is
7-13
Advertisement
Table of Contents
