Hitachi XP P9500 User Manual page 244

In the sub-parameters, -hdev or -pathid, you can filter the LU
information to be displayed. If you omit both parameters, the command
displays the information about all the LUs recognized by HDLM.
For details on the contents of each displayed item, see
Displayed LU Information on page
The sub-parameters are:
-hdev host-device-name
-pathid AutoPATH_ID
-exlu
-t
Example:
6-56
Displays information only for the paths accessing the specified host
device.
Specify a drive letter to indicate the desired host device. You cannot
specify the host device unless a drive letter has been assigned. The
host-device-name string is case sensitive. If the command ends with
the KAPL01064-W or KAPL01013-E message, follow the recommended
action in the message.
Use this parameter to display only the information about the LU that
is connected to the path with that specified AutoPATH_ID.
• When an HDLM management-target device is the EMC DMX series,
EMC CX series, or HP EVA series:
If this parameter is specified, all 32 digits of the iLU are displayed
instead of truncating the iLU to 13 digits. If this parameter is not
specified, any characters after the 13
DMX series, EMC CX series, and HP EVA series will not be
displayed. Ellipsis (...) will be displayed instead.
• When an HDLM management-target device is only the Thunder
9500V series, Lightning 9900 series, Lightning 9900V series,
Hitachi USP, Hitachi AMS2000/AMS/WMS/SMS series, Universal
Storage Platform V/VM, or Virtual Storage Platform:
16 digits or less are displayed for the iLU even if this parameter is
specified.
Omits the title for each information item.
The following example shows how to add SLPR, PathName, ChaPort,
CLPR, Type IO-Count, IO-Errors, DNum, and IEP to the displayed
items for LU information.
Command Reference
Hitachi Dynamic Link Manager User Guide (for Windows(R))
6-60.
th
digit of the iLU of the EMC
Table 6-18