Firewall_Setup Command Syntax - Hitachi XP P9500 User Manual

2 Execute the firewall_setup command.
.
3 Check the displayed message to make sure that the command was
.
executed successfully.
The command ended successfully.

firewall_setup command syntax

If the host OS is Windows, the firewall_setup command is used to register
the ports used by the Hitachi Command Suite Common Agent Component as
firewall exceptions.
The firewall_setup command is stored in the following locations:
installation-folder-for-Hitachi-Command-Suite-Common-agent-Component
\bin\firewall_setup.bat
Table 3-13 firewall_setup command syntax on page 3-67
firewall_setup command syntax.
Synopsis
Description
Options
Note:
In Windows, the folder in which the Hitachi Command Suite Common
Agent Component commands are installed is automatically added to the
environment variable Path. When you execute a command, you do not
need to change the current folder to the folder that contains commands.
Table 3-13 firewall_setup command syntax
Item
firewall_setup {-set|-unset}
Registers the following ports used by the Hitachi Command Suite
Common Agent Component in a Windows environment as firewall
exceptions:
• Port set for the server.agent.port property (default: 24041/
tcp)
• Port set for the server.http.port property (default: 24042/
tcp)
• Port set for the server.http.localPort property (default:
24043/tcp)
This operation requires Administrator privileges. If the OS is
Windows Server 2008 or Windows Server 2008 R2, the command
must be executed from a command prompt started as an
Administrator.
-set
Adds firewall exceptions.
-unset
Removes firewall exceptions.
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Windows(R))
describes the
Details
3-67