The default configuration of the attachment ports (the two leftmost ports on the
module installed in slot 1) is B/A. If the attachment ports have been configured
differently (as shown by the ATTACH LEDs on the management module), you
must reconfigure them, as detailed below:
1.
Configure the attachment ports as B and A. Type:
set attach
This selection prompt appears:
Select one of the following:
1. B/A
2. S/M
3. M/M
Attachment port configuration?
2.
Select the attachment port configuration that you want. For example,
type:
1 [Enter]
These confirmation lines appear:
Current configuration:
Initialize attachment as:
3.
Reset the hub by pressing the recessed RESET button on the
management module front panel.
The attachment ports will be initialized as B/A.
Installing the Hub
M/M
B/A
2-25