Set Boot - 3Com 3C780 - LinkBuilder FDDI Base Unit User Manual

You can also enter the baud rate on the same line with the set baud command, as
shown below:
set baud 4800 [Enter]

set boot

Syntax
set boot [method | filename | server]
Simplified Syntax
set boot method
set boot filename
set boot server
Description
The set boot method command allows you to select the method to use when
downloading an image to the flash EPROM. The available options are:
LOCAL Loads and runs the flash EPROM code (default)
TFTP Uses TFTP and local configuration parameters to load a new
image over the network
The set boot filename command allows you to set the filename of the software
image to be loaded when using TFTP.
The set boot server command allows you to set the IP address of the boot server.
Examples
An example of each option is shown below:
When you enter the set boot method command, you are prompted to select
the server location of the information to be downloaded, as shown below:
Select one of the following:
1. LOCAL
2. TFTP
Boot Method?
Commands
C-3