3Com 3C780 - LinkBuilder FDDI Base Unit User Manual page 78

3-10 Configuring the Hub
3.
4.
If your attempt to enter the primitive console command mode fails and the
timeout occurs, you can try again by following the steps above.
If you do not press the RESET button during the 10 seconds that the
STATUS LED is flashing amber/green, you are denied access to the
primitive console command mode, and this message appears:
Primitive console entry has timed out.
Press RESET again.
This message appears:
Press Ctrl-P to enter Primitive Console.
Hold down the [Control] and [P] keys.
The hub is now in the primitive console command mode. The STATUS
LED flashes amber/green continuously while you are in the primitive
console command mode.
If you do not enter a primitive console command within 15 seconds, an
inactivity timeout will cause the hub to return to the management console
command mode.
If you do not press [Ctrl]+P within 10 seconds, the system times out.