Table of Contents
Advertisement
show log and clear log Commands
The fault log keeps a limited history of recent faults that have occurred in the
system.
To display the fault log, type:
show log
A typical fault log is shown below:
Fault Log:
1. 10000001
2. 10000002
The first column shows the order of all faults since the last clear log
command. The second column is the code specifying the type of fault.
(Refer to "Fault Log Error Code Messages" in Appendix A for
explanations of the error codes.) The third column is a time stamp (in
seconds), showing when the fault occurred. (The timer is restarted after
each reset.) The fourth column is the number of resets since the last
recorded reset.
To clear the fault log, type:
clear log
To display the fault log in reverse order, type:
show log last
This could be helpful when there are a large number of faults in the log and
you want to see the last one first.
Using the Hub
0#
0
0#
0
5-21
Advertisement
Table of Contents
