Returning To The Management Console Command Mode; Port Connections - 3Com 3C780 - LinkBuilder FDDI Base Unit User Manual

Returning to the Management Console Command Mode

To return to the management console command mode without reattempting to
enter the primitive console command mode, follow these steps:
1.
2.
To return to the management console command mode from the primitive
console command mode, reset the hub.

Port Connections

The two leftmost ports on any module installed in slot 1 serve as attachment
ports. You can configure these ports to be any of the following:
The way you configure these ports determines the type of attachment supported
by the hub. The configurable attachment types are as follows:
Table 3-2 shows how to configure the attachment ports for the desired
attachment type.
Press [Enter].
This message appears:
®
3Com LinkBuilder
The password prompt appears.
Enter the password and press [Enter].
B/A (dual attachment)
S/M (slave/master)
M/M (master/master)
Dual attachment
Dual homing attachment
Single attachment
Null attachment
FDDI Workgroup Hub
Configuring the Hub
3-11