Hub Chassis; Media Port Modules - 3Com 3C780 - LinkBuilder FDDI Base Unit User Manual

2-6 Installing the Hub
If you ordered a fiber media module, four small packets of fiber port module
keys will be included with the module. For information on installing these keys,
see the section "Keys for Fiber Port Modules" later in this chapter.
If you ordered an STP media port module, one cascade connector will be
shipped with the module. For information about the cascade connector, refer to
the section "STP Cascade Connector" later in this chapter.
NOTE: Remember to fill out the Product Registration Card at the back of this
manual and return it to 3Com, or call 1-800-NET-3Com for immediate
registration.

Hub Chassis

The LinkBuilder FDDI hub is shipped with no modules installed; the modules
you ordered are shipped separately and packaged individually. The hub is
shipped with two blanking plates attached over slots 2 and 3.
Install the management module in slot 0. Install one of the media port modules
in slot 1. To install additional modules, remove the blanking plates and insert
the modules. Retain the blanking plates for possible future use when modules
are removed. (Refer to the section "Installing Modules" later in this chapter for
complete information about mounting the modules in the hub.)

Media Port Modules

Depending on your order, you should also have received one or more of the
following modules:
LinkBuilder FDDI 4-port fiber port module
LinkBuilder FDDI 6-port STP port module
LinkBuilder FDDI 8-port UTP port module