Primitive Console Commands - 3Com 3C780 - LinkBuilder FDDI Base Unit User Manual

Simplified Syntax
route add destination
route add destination gateway
route add destination gateway metric
route delete destination
route delete destination gateway
route delete destination gateway metric
route dump
Description
The route command adds or deletes a path to a particular device or hub, where:
The route dump command displays the current IP addresses of the destination
and gateway.

Primitive Console Commands

The primitive console command set contains three categories of commands:
NOTE: The primitive console commands are a subset of the management
console commands. The command descriptions are therefore abbreviated. For
complete command descriptions, refer to the section "Management Console
Commands" earlier in this appendix.
destination is the destination IP address.
gateway is the gateway IP address.
metric is the number of hops (number of gateways
separating the source and destination) to the
network. (Optional)
Set commands
Display commands
Miscellaneous commands
Commands
C-19