Displaying The Current Download Method - 3Com 3C780 - LinkBuilder FDDI Base Unit User Manual

4-14 Setting Up the Hub
7.
8.

Displaying the Current Download Method

To display the current download method, enter the show boot method command.
This command displays the current download method, the IP address of the boot
server, and the filename of the image, as shown below:
Boot parameters
To display the status of the last download, enter the show boot load command.
An example of the resulting display is shown below:
Last download
NOTE: For a list of the last download status messages that may be displayed,
refer to the section "Download Messages" in Appendix A.
Enter the default gateway's IP address. For example, type:
set gateway 123.44.66.88 [Enter]
Your local administrator should provide the gateway address you need.
Reset the hub.
Press the RESET button.
The new image is now downloaded and stored in the flash EPROM. If no
errors are encountered, the hub is reset and the new image is executed.
Method :TFTP
Server :128.34.56.78
Filename :newimage
Status : TFTP download completed successfully
Method : TFTP
Server : 128.34.56.78
Filename : newimage